Each SEALOCK Security System includes the
following parts:
(1) Right-Hand door Bracket made
of 100% steel with serial number to match each other component
deeply stamped into the metal and highlighted in day-glo orange
paint.
(1) All-steel J-Bar with serial
number to match each other component deeply stamped into the metal
and highlighted in day-glo orange paint.
(1) Braided steel cable with
bullet tip on one end and a seal with a matching serial number and
the word "SEALOCK" embossed thereon on the other end.
Right-Hand Door Bracket
The 3
Components of the
SEALOCK Security System
INSTALLATION
INSTRUCTIONS
Slide the Right-Hand Bracket around the
container's right side locking rod.
(Figure 3)
Insert the J-Bar into the Right-Hand Bracket
and make sure to hook the J-shaped left side of the bar around the
container's left-side locking rod and slide it as far to the right
as it will go. Line up the nearest hole in the bar with the hole
in the bracket. (Figure 4A & 4B)
Insert the bullet-tipped end of the cable seal
into the container's sealing aperture as indicated in Figure 5.
Firmly insert one end of the braided steel
cable into the Bracket. To make sure it's locked in place, give it
a few hard tugs to make sure it is seated properly & can't be
pulled loose. (Figure 6)
Record the seal number on your shipping
documents.
Figure 3
Figure 4A
Figure 4B
Figure 5
Figure 6
Completely installed
Sealock SU2005
REMOVAL
INSTRUCTIONS
Cut the steel bar where shown in Figure 7 using
an angle grinder or reciprocating saw.
Cut the cable seal to unseal the door handle
using the same power tool or a bolt cutter and discard the parts
as they cannot be reused.
Always wear eye protection
when using power tools.
En Español 
